[Triad]

The Shoulder Turn Throw is a Trigger Type, whereas Shoulder Turn Thrust describes the use of the Right Shoulder to drive the Lever Assemblies and is not a Trigger Type. You need Shoulder Turn Thrust to use the Shoulder Turn Throw.

For both Hitters and Swingers, the Right Shoulder is used to overcome the initial inertia of the Clubhead during the change in direction. After this inital phase, the Hitter uses the Right Shoulder as a backstop for the Right Arm to push off. However, for the Swinger, the Right Shoulder continues to actively drive down plane against Pressure Point #4. Only for the Full Power Four Barrel Hitting Stroke does the Right Shoulder continue to be active, but it is still used by the Right Arm to push off.
Whatever you choose to do, the Right Shoulder is always leading the Hands (i.e. lagging Hands, Arm and Club -- "Pivot Lag").

Thanks Tong. I have a few more questions, but it may be more appropriate to start a new thread on them. However, if you could humor me for one quick one to jump start my thought process I would appreciate it. I have always been a little blurry on the difference between Trigger Types and Release Types. My basic thought is that Trigger Types refer to the how of the accumulator release sequence whereas Release Types refer to the when/wherethey are released. That is to say that, for instance, the Wrist Throw trigger could occur at the TOP/Startdown for a Full Sweep release, or much deeper, say at Aiming Point for a Snap Release. Both procedures would be using the same Trigger Types, but at different Release Types/points. Am I on track here?
Thanks,
Triad